Useful Netapp commands (4047349)

Date: 7/2007
Affected NV Version: Any
OS Version: Ontap 7.x and up
Plugin version: NDMP any
Application version: N/A

Description: Useful Netapp commands

Symptoms: None

version shows the Ontap version

ifconfig -a shows the IP address

uptime shows how long the filer has been up

ndmpd variables:
on - Enables NDMP request-handling by the daemon. Enabling/disabling NDMP persists across reboots.

off - Disables NDMP request-handling by the daemon. Processing continues for requests that are already in progress. New requests are rejected. By default, NDMP service is disabled at system startup.

status - Displays the current state of NDMP service.

probe [ session ] - Displays diagnostic information about the specified session. If session is not specified, information about all sessions is displayed.

kill session - Signals the specified session to stop processing its current requests and move to an inactive state. This allows hung sessions to be cleared without the need for a reboot, since the off command waits until all sessions are inactive before turning off the
NDMP service.

killall - Signals all active sessions to stop processing their current requests and move to an inactive state.

version [ maxversion ] - Displays the maximum version that
NDMP currently supports when invoked without the optional maxversion. Sets the maximum version that NDMP allows when maxver_sion is specified. Currently supported values of maxversion are 2,3, and 4. By default, the maximum version is set to 4 at system startup. If maxversion is changed with ndmpd version maxversion, the changed value persists across reboots.

snapmirror status shows if snapmirror is enabled

sysconfig -m shows attached media changers

sysconfig -t shows attached tape drives