Replicator installations can be run directly from a command prompt without prompting for additional information. For more information on the installation and configuration commands, see the Replicator Command Line Reference Guide.
By following the install process, we expect that most users will be able to install and configure Replicator in approximately four hours. The actual time required will vary based on the amount of preparation tasks you perform before running the Metalogix Replicator installer, the number of servers you have in a farm, and the number of farms you have in total.
The following tables describe the hardware, software, and access requirements for Metalogix Replicator. If our requirement is equivalent or less restrictive than a SharePoint requirement, then we do not document it here.
|
Component |
Requirement |
|---|---|
|
Processor |
Under normal circumstances, the Replicator processor requirements are the same as SharePoint. When replicating large amounts of SharePoint content, Replicator uses a greater amount of CPU capacity. The expected load is comparable to up to 10 full time users accessing the web front end. |
|
Memory |
Replicator Basic and Standard editions require at least 1.25 GB of available memory.
Replicator Enterprise Edition requires at least 1.5 GB of available memory.
Additionally, ensure there is approximately 10 times the size of the largest file you expect to replicate in available memory.
For example, if you are using Replicator Standard Edition and expect to replicate files that are 25 MB and smaller, then you should have 1.5 GB (1.25 + 10 x 0.025) of available memory for Replicator. |
|
Disk Space |
At least 500 MB of free disk space in the %TEMP% folder of the server where Replicator is installed.
At least 20 GB of free disk space in a shared network folder. This is for your Replicator Data Folders. This number is a rough guideline and is affected by how frequently changes occur in your SharePoint environment, how often packages are cleared, and several other Replicator configuration settings.
At least 4 GB of free disk space in SQL Server is required where the SharePoint configuration database is stored. |
© ALL RIGHTS RESERVED. 利用規約 プライバシー Cookie Preference Center
