サポートと今すぐチャット
サポートとのチャット

NetVault Plug-in for VMware 11.2 - User Guide

Introduction Installing the plug-in Configuring the plug-in Defining a backup strategy Using the image-level backup method Using the file-level backup method Restoring image-level backups Restoring file-level backups Troubleshooting

Configuring the plug-in

Adding a server

Before you can use the plug-in for backups and restores, you must add the applicable VMware® ESXi™ and VMware® vCenter™ Servers to the plug-in, and configure a user account to log on to the server.

Standalone ESXi Server setup: In a VMware environment that consists of one or more ESXi Servers, add the individual hosts to the plug-in, and configure a user account for each server.
Cluster setup: In a cluster setup managed by a vCenter Server, add the vCenter Server to the plug-in, and configure a user account for this server.
1
In the Navigation pane, click Guided Configuration, and then on the NetVault Configuration Wizard page, click Create Backup Jobs.
2
Click Create New next to the Selections list to open the NetVault Backup Selections page.
4
In the Actions list, click Add Server.
Table 1. Add Server

Server Name

In a standalone server setup, type a name for the ESXi Server.

In a cluster setup, type a name for the vCenter Server.

The server name must be unique. If you do not provide a name, the plug-in uses the Server Address as the server name.

You cannot change the server name once it is configured.

Server Address

In a standalone server setup, type the Fully Qualified Domain Name (FQDN) of the ESXi Server.

In a cluster setup, type the FQDN of the vCenter Server.

You can also specify the IP address of the server, but using FQDN is the preferred method.

User

Specify a user account that can be used to log on to the configured server. The user account must have privileges to register or create virtual machines.

Password

Type the password for the user account.

Reconfiguring a server

1
Start the Backup Job Wizard, and click Create New next to the Selections list.
4
In the Actions list, click Edit Server.
For more information about these settings, see Add Server. In the Edit Server dialog box, the server name is displayed as a read-only setting.

Removing a server

1
Start the Backup Job Wizard, and click Create New next to the Selections list.
4
In the Actions list, click Remove Server.
関連ドキュメント

The document was helpful.

評価を選択

I easily found the information I needed.

評価を選択