サポートと今すぐチャット
サポートとのチャット

NetVault Plug-in for VMware 11.1 - User Guide

Introduction Installing the plug-in Configuring the plug-in Defining a backup strategy Using the image-level backup method Using the file-level backup method Restoring image-level backups Restoring file-level backups Troubleshooting

Restore selection tree icons

Virtual machine

Failed virtual machine (appears in a saveset for stopped job)

Configuration file

NVRAM file

Virtual machine disk file

Disk extent information file

Log file

Catalog file

Starting a virtual machine

After a virtual machine is restored, it is in powered off state. You must start it manually. When you start the virtual machine, the operating system might prompt to perform an error recovery or record the reason for the unclean shutdown. In most cases, you can ignore this message and select the normal boot option.

Relocating a virtual machine to an alternate ESXi Server

1
Complete Step 1 through Step 4 in the section Restoring data.
2
Click Edit Plugin Options. Depending on your VMware environment, configure the applicable options in the Plug-in for VMware Restore Options dialog box.
Cluster setup: To relocate a virtual machine in a cluster setup, configure the following options on the Restore virtual machine under vCenter tab.

Recover virtual machine under vCenter

To restore a full virtual machine or one or more virtual disks, select this option.

Alternate Datastore

Specify the destination datastore name for the virtual machine. For more information about this option, see Alternate Datastore.

This option is required when relocating a virtual machine. If you do not specify this job, the restore job fails.

Standalone ESXi Server setup: To relocate a virtual machine to a standalone ESXi Server, click the Restore virtual machine to standalone ESXi host tab, and configure the following options.

Recover virtual machine under vCenter

To restore a full virtual machine or one or more virtual disks, select this option.

Alternate Datastore

Specify the destination datastore name for the virtual machine. For more information about this option, see Alternate Datastore.

This option is required when relocating a virtual machine. If you do not specify this job, the restore job fails.

Host

Type the IP address or DNS name of the alternate ESXi Server host.

User Name

Specify a user account that can be used to log on to the ESXi Server. The user account must have privileges to register or create virtual machines

Password

Type the password for the user account.

3
Complete Step 5 through Step 10 in the section Restoring data.
4
Select the Disassociate host from vCenter Server check box.

For more information, see the relevant vSphere documentation.

Renaming a virtual machine during restore

To restore a virtual machine or its individual disks without overwriting the existing copy, you can rename the virtual machine during restore. The plug-in creates a virtual machine and restores the contents of the selected disks.

1
Complete Step 1 through Step 4 in the section Restoring data.
3
In the Restore Rename dialog box, provide the following information:
Rename To: Select this check box, and type a new name for the virtual machine in the associated box. The name can contain a maximum of 80 characters. It cannot include any special characters (such as, / \ ? * : @ > < | " ? &). If you specify more than 80 characters or use any special character in the virtual machine name, the job reports an error and fails.
Click OK to close the dialog box.
4
Complete Step 5 through Step 10 in the section Restoring data.
関連ドキュメント

The document was helpful.

評価を選択

I easily found the information I needed.

評価を選択