The DR2000v uses a standalone license.
For more information on DR2000v license limits, see the DR Series System Interoperability Guide. For more information about DR2000v Hyperscale licensing, contact your sales representative or Quest support.
Refer to the following notes about GUI usage specific to the DR2000v.
http://www.dell.com/support/home/us/en/19/Drivers/DriversDetails?driverId=CYKKJ&osCode=MWS80&fileId=3197327398&languageCode=EN&categoryId=NI
a. |
Ensure the virtual switch settings MAC address changes and Forged Transmits are set to Accept, if you are planning to use eth-1 in an ESXi hypervisor environment. |
4. |
If you are making any network setting changes on your hypervisor, execute the stats –network CLI command to list all the NIC ports status, especially with the Rx/Tx counts. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. 利用規約 プライバシー Cookie Preference Center