Configuration and administration of NetVault SmartDisk is handled primarily through the NetVault SmartDisk CLI. Using the smartdisk.sh shell on Linux, UNIX, and Mac OS X, or the smartdisk.bat shell on Windows, you can perform basic functions such as accessing help regarding the available commands, and configuring, monitoring, starting, and stopping NetVault SmartDisk. On Windows, the .bat extension is optional. To eliminate the requirement to specify the extension on Linux, UNIX, and Mac OS X, NetVault SmartDisk uses a symbolic link from smartdisk to smartdisk.sh.
To simplify the commands and code samples shown throughout this document, forward slashes are used and the .sh and .bat extensions are not shown. Also, an ellipsis (…) represents the path to where you installed NetVault SmartDisk. Replace the ellipsis with the applicable information.
To use a Run as Administrator command prompt, perform the following steps.
1 |
2 |
3 |
2 |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback 利用規約 プライバシー Cookie Preference Center