サポートと今すぐチャット
サポートとのチャット

DR Series DR4300e - Owner's Manual

DR4300e system overview Technical specifications Initial system setup and configuration Pre-operating system management applications
Options to manage the pre-operating system applications System Setup Dell Lifecycle Controller Boot Manager PXE boot
Installing and removing system components
Safety instructions Before working inside your system After working inside your system Recommended tools Front bezel (optional) System cover Cooling shroud Cooling fans Cooling-fan assembly System memory Processors and heat sinks PCIe card holder Cable retention bracket Integrated storage controller card Expansion cards and expansion card riser Internal dual SD module (optional) Network daughter card Internal USB memory key (optional) System battery Power supply units (PSU) System board Trusted Platform Module Hard drives Hard drive backplane SD vFlash card (optional) Control panel assembly
Using system diagnostics Jumpers and connectors Troubleshooting your system

Removing a 3.5-inch hard drive blank

This figure shows removing a 3.5-inch hard drive blank

If applicable, install the front bezel.

Installing a 3.5-inch hard drive blank

This figure shows installing a 3.5-inch hard drive blank

If applicable, install the front bezel.

Removing a hot swappable hard drive or SSD

For more information, see the documentation for the storage controller.

This figure shows removing a hot swappable hard drive or SSD.

Installing a hot-swap hard drive

This figure shows installing a hot-swappable hard drive or SSD.

関連ドキュメント

The document was helpful.

評価を選択

I easily found the information I needed.

評価を選択