サポートと今すぐチャット
サポートとのチャット

NetVault Plug-in for SnapVault Manager 10.0.1 - User Guide

Installing the plug-in

The Plug‑in for SnapVault Manager only functions on a Server installation of NetVault Backup. For details on installing the NetVault Backup Server software, see the Quest NetVault Backup Installation Guide.

1
In the Navigation pane, click Guided Configuration, and then on the NetVault Configuration Wizard page, click Install Plugins. In the NetVault Backup Clients list, select the clients on which you want to install the plug-in. This method allows you to install the plug-in on multiple clients at the same time (if the selected clients are all the same type).
* 
NOTE: When you select multiple clients, make sure that the plug-in binary file is compatible with the OS and platforms of the target clients.
– or –
In the Navigation pane, click Manage Clients. In the NetVault Backup Clients list, select the client on which you want to install the plug-in, and click Manage. At the lower-right corner of the Installed Software table, click the Install Plugin button ().
2
Click Choose Plug-in File, and in the browse window, navigate to the location of the “.npk” installation file for the plug-in (on the installation CD or the directory to which the file was downloaded from the website).
3
Select the file named nsv-x-x-x-x.npk (x-x-x-x represents the version, build, and platform numbers), and click Next to begin installation.
After the plug-in is installed successfully, a message is displayed.
4
To complete the installation, close the NetVault Backup WebUI, and restart the NetVault Backup Service.

Removing the plug-in

1
In the Navigation pane, click Manage Clients.
2
In the NetVault Backup Clients list, select the client on which the plug-in is installed, and click Manage.
3
In the Installed Plug-ins table, select SnapVault Manager Plugin, and click the Remove Plugin button ().
4
In the confirmation dialog box, click Remove.

Configuring the plug-in

•
Adding the SnapVault Primary and Secondary Systems
•
Available commands in the Actions list
•
Configuring default settings
•
Using SnapVault password utility

Adding the SnapVault Primary and Secondary Systems

Before you can start using the plug-in, you must add both the SnapVault Primary and Secondary systems to the NetVault Backup Server for use (including the NetVault Backup Server itself, acting as an SV Primary).

関連ドキュメント

The document was helpful.

評価を選択

I easily found the information I needed.

評価を選択