サポートと今すぐチャット
サポートとのチャット

Foglight Evolve 9.3 - Foglight Evolve Virtual Appliance Installation and Setup Guide

Upgrade the virtual appliance

This section provides instructions for upgrading the Foglight-Evolve-vApp virtual appliance.

For details, see these topics:

•
Upgrade paths
•
Upgrade the vApp

Upgrade paths

The Foglight Evolve 9.3 virtual appliance can be directly upgraded from Foglight Evolve 9.0, 9.1, and 9.2, and Foglight for Virtualization, Enterprise Edition version 8.8, 8.8.5, 8.9, 8.9.1, and 8.9.2. To upgrade from Foglight for Virtualization, Enterprise Edition version 8.7.5, 8.7, 8.6, you must first upgrade the virtual appliance to version 8.8, then to version 9.3.

Upgrade the vApp

To upgrade the virtual appliance:
1
Download the Foglight Evolve Linux x86 64 installer from Quest Support:
https://support.quest.com/foglight-evolve/9.3/download-new-releases
2
In preparation for the upgrade, take a backup or snapshot of all relevant VMs. This includes both the FMS, FglAM, and DBS VMs, as well as any additional VMs hosting agents.
 
3
Immediately prior to upgrading, deactivate all running agents. This can be done individually from the Administration tab on each domain's Environment dashboard, or from the dashboard found in Dashboards > Administration > Agents > Agent Status.
4
Using an sftp client (for example, Bitvise SSH Client), connect to the FMS machine on port 22,
sftp://IP of FMS:22, as the foglight user. The password is foglight if it has not been changed after installation.
5
Extract the files from the downloaded zip file and copy the installer to the directory:
/home/foglight/Quest/Foglight/upgrade
6
Log into the FMS VM console as the user foglight (default password is foglight).
7
Type the following command to set execute permissions on files in the upgrade folder for the foglight user:
chmod -R 744 /home/foglight/Quest/Foglight/upgrade
8
Run the following command to start the upgrade process:
/home/foglight/Quest/Foglight/upgrade/Foglight-Evolve-<version>-install_linux-x86_64.bin -i console
9
Follow the prompts to accept the license agreement.
10
When prompted for an installation directory, enter (case sensitive):
/home/foglight/Quest/Foglight
11
When prompted, select 1 for upgrade.
12
When prompted after the Pre-Installation Summary, press Enter to continue.
13
When prompted for the database running state, press Enter to continue.
14
When prompted, select 1 to Run Now.
15
When prompted, press Enter to exit the installer.
It usually takes five to ten minutes for the FMS to start up and be ready for login.
 
* 
TIP: Run the following command and monitor the cpu utilization for the fms process.
top -u foglight
It will be very busy while the upgrade is finishing, but it settles down to a few percent when it is ready to login.
16
Allow the startup to complete, then login using a browser.
17
To complete Foglight Agent Manager (FglAM) and agent upgrade, see the “Upgrade the Foglight Agent Manager” in the Foglight Upgrade Guide.

 

関連ドキュメント

The document was helpful.

評価を選択

I easily found the information I needed.

評価を選択