vRanger 7.8.2 - Integration Guide for EMC Data Domain Boost (DD Boost)

Initializing the DR Series

Initializing the DR Series

Before you can start using the DR Series system GUI for the first time, you must properly initialize the system. To initialize the DR Series system, complete the following:

1	Log in to the DR Series system CLI by using a local console KVM connection or an iDRAC connection.

2	Configure your system network settings using the Initial System Configuration Wizard.

This wizard lets you configure the following network settings to complete a first-time initialization of your system:

▪	IP addressing mode

▪	Subnet mask address

▪	Default gateway address

▪	DNS suffix address

▪	Primary DNS server IP address

▪	[Optional] Secondary DNS server IP address

▪	Host name for system

Configuring local console connections

Configuring local console connections

To configure a local console connection, you must make the following two back chassis cable connections:

•	VGA port and your video monitor

•	USB port and your keyboard

 

IMPORTANT: For more information, including port diagrams, see the Quest DR Series System Administrator Guide.

To make local console cable connections for the DR Series appliances:

1	Locate the VGA monitor port and the USB ports on the back of your system.

1	Connect the video monitor to the VGA port on the back of your system.

2	Connect the USB keyboard to one of the two USB ports on the back of your system.

You are now ready to perform initialization using the DR Series system CLI login process.

Configuring the iDRAC connection

Configuring the iDRAC connection

The iDRAC connection requires a network connection between the integrated Quest Remote Access Control (iDRAC) management port on the DR Series system and another computer running the iDRAC remote console session in a supported browser. The iDRAC provides remote console redirection, power control, and the out-of-band (OOB) system management functions for the DR Series system. iDRAC connections are configured using console redirection and the iDRAC6/7 web interface. The login values you can use for making iDRAC connections are:

•	Default username: root

•	Default password: calvin

•	Default static IP address: 192.168.0.120

 

NOTE: For information on how to configure the iDRAC, see the Dell RACADM Command Line Reference Guide at http://www.dell.com/support/home.

When the Quest DR Series System splash screen is displayed, you are ready to begin initialization using the DR Series system CLI login process.

Logging in and initializing the DR Series

Logging in and initializing the DR Series

Use the DR Series system CLI and the Initial System Configuration Wizard to log in to and initialize the system. After completing a local console or iDRAC connection, log in to the DR Series system CLI:

1	Launch a terminal emulator application, such as PuTTY, and type the default IP address, 10.77.88.99, for the DR Series system, if you are not using iDRAC or a local console.

2	At the login as: prompt, type administrator, and press Enter.

3	At the administrator@<system_name> password: prompt, type the default administrator password, St0r@ge!, and press Enter.

4	To configure the network settings, type y (for yes), and press Enter.

When completed, a successful initialization message is displayed.

 

NOTE: For complete information on configuring networking, see “Logging in and Initializing the DR Series System” in the Quest DR Series System Administrator Guide.

5	At the prompt, type exit, and press Enter to end the DR Series system CLI session.

You are now ready to log in to the system using the DR Series system GUI.

 

NOTE: Before you log in to the system using the DR Series system GUI, make sure to register it in the local Domain Name System (DNS) for your network so that it is a DNS-resolvable entry.