Before installing the Plug-in for SAP HANA, verify that the following software is installed and configured:
• |
NetVault Backup Server or Client software: At a minimum, the Client version of NetVault Backup software must be installed on the machine hosting the SAP HANA database. For an example of a suitable environment, see Reviewing the recommended configuration. |
• |
SAP HANA software: This database software must be installed and properly configured on the machine serving as the SAP HANA Server. |
• |
Client added to the NetVault Backup Server for access: If the machine that hosts the targeted SAP HANA database is not the NetVault Backup Server, this machine must be added to the NetVault Backup Server as a NetVault Backup Client. For more information, see the Quest NetVault Backup Administrator’s Guide. |
While you can set up a single machine as both the NetVault Backup Server and the SAP HANA Server, that is, all software installation and configuration requirements are performed on a single machine, Quest recommends that these two entities exist on separate machines. The following table displays an ideal setup for use with the Plug-in for SAP HANA, including the software and configuration requirements to establish this type of environment.
Software installed/configuration
|
Software installed/configuration
|
1 |
• |
To access the NetVault Configuration Wizard page: |
a |
In the Navigation pane, click Guided Configuration. |
b |
• |
To access the Manage Clients page: |
a |
In the Navigation pane, click Manage Clients. |
b |
On the Manage Clients page, select the machine that contains the SAP Backint database, and click Manage. |
c |
2 |
Click Choose Plug-in File, navigate to the location of the “.npk” installation file for the plug-in, for example on the installation CD or the directory to which the file was downloaded from the website. |
3 |
Select the file entitled “hana-x-x-x-x-x.npk,” where xxxxx represents the version number and platform, and click Open. |
4 |
IMPORTANT: The Plug-in for SAP HANA must exist on the NetVault Backup Server, regardless of the configuration in use. Therefore, if you are using a single machine configuration, installation is complete. If you are using the recommended Client/Server configuration, repeat the installation process, this time installing the plug-in on the NetVault Backup Server.
The plug-in installation file depends the OS in use. The same installation file cannot be used for different operating systems. Therefore, if you are using the recommended configuration and the NetVault Backup Server and SAP HANA Server are each running a different OS, the proper installation files must be obtained and used; that is, from the plug-in installation CD or from the Quest website. |
5 |
Install the license for Plug-in for SAP HANA. |
6 |
After the plug-in is installed, on the NetVault Backup Server, locate and open the “allowdupjobname.cfg” file in a text editor. |
7 |
9 |
Create a symbolic link for hdbbackint. |
a |
b |
© ALL RIGHTS RESERVED. Feedback 利用規約 プライバシー Cookie Preference Center