Plug‑in for Oracle uses an Oracle® “SBT_TAPE” channel to conduct backups of an Oracle database. SBT is commonly used to specify a destination for RMAN commands used to back up to tape media. For complete information on establishing this type of channel for use, see Configuring and Allocating Channels for Use in Backups in the Oracle Database Backup and Recovery Advanced User’s Guide.
IMPORTANT: Jobs that are generated using the RMAN CLI cannot be re-run using the NetVault Backup WebUI. The RMAN CLI command, that is, the RMAN script, is not sent from the RMAN CLI application back to NetVault Backup. So, if you select Run Now on the Job Status page, the job fails. |
If the password for the NetVault Backup default user has been set or a non-default NetVault Backup user is used to run the backup and restore, you must run the nvpluginaccess utility on the NetVault Backup Server. You must then obtain the necessary security clearance for the plug-in to perform CLI backups and restores.
The nvpluginaccess utility is available in the “util” directory on the NetVault Backup Server.
1 |
Initiate a command-line session, and navigate to the “util” directory: |
• |
• |
5 |
Verify that the nvpluginaccess utility has been correctly configured by reviewing the contents of the “hookplugs.cfg” file located in the “config” directory: |
• |
• |
NOTE: The Password field in the “hookplugs.cfg” file contains an encrypted view of the password. The actual password is not displayed. |
The following topics provide information for performing CLI-based backups:
This topic shows how to take a Full Backup of the “USERS” tablespace using RMAN commands:
1 |
Log on to the Oracle® Database Server, and initiate a terminal session. |
2 |
From the prompt, generate a “Run Block” as follows: |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Termini di utilizzo Privacy Cookie Preference Center