You can turn client-side optimization On or Off by using the CLI commands, rda --update_client --name --mode. For more information about DR Series system CLI commands, see the DR Series System Command Line Reference Guide.
To add RDS devices in NetVault Backup:
◦ |
In the Navigation pane, click Guided Configuration, and then, on the NetVault Configuration Wizard page, click Add Storage Devices. |
◦ |
3. |
4. |
5. |
NOTE: The Username, backup_user is case-sensitive. You can configure RDS containers only while logged on the DR Series system with username backup_user. |
6. |
7. |
8. |
In Block size, enter the block size for data transfers. The block size is specified in bytes. The default block size is 131,072 bytes. |
9. |
If the device is already added to another NetVault Backup Server with the same name, select the Force add check box. This option can be useful if you have performed a disaster recovery to rebuild the NetVault Backup Server. |
10. |
Refer to the following steps to remove existing RDS devices from NetVault Backup.
2. |
3. |
4. |
If NetVault Backup fails to remove the device, select the Force Removal check box in the confirmation dialog, and click Remove. |
You must back up data on the RDS container (available on the DR Series systems) using NetVault Backup. Before you can back up data using the RDS protocol, you must create an RDS container on the DR Series system and then add that container as an RDA device on NetVault Backup. For more information see, Adding RDS Devices in NVBU.
To back up data on the RDS container:
3. |
In the Selections list, select an existing Backup Selection Set, or click Create New, and select the items that you want to back up. The selection tree is plug-in specific. For more information about selecting data for backups, see the relevant NetVault Backup plug-in user's guide. |
4. |
In the Plugin Options list, select an existing Backup Options Set, or click Create New, and configure the options that you want to use. These options are plug-in specific. For more information about these options, see the relevant NetVault Backup plug-in user's guide. |
5. |
In the Schedule list, select an existing Schedule Set, or click Create New, and configure the schedule type and schedule method. For more information about these options, see the Dell NetVault Backup Administrator's Guide. To run the job as soon as it is submitted, use the "Immediate" set. |
6. |
In the Target Storage list, select an existing Target Set, or click Create New, and configure the target device and media options for the job. |
7. |
In the Advanced Options list, select an existing Backup Advanced Options Set, or click Create New, and configure the options that you want to use. |
8. |
The backup job may take a few minutes to complete depending on the amount of data that is backed up. You can view the progress of the backup job by using the Job Management section of NetVault Backup. For more information about using NetVault Backup, see the Dell NetVault Backup Administrator's Guide.
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Termini di utilizzo Privacy Cookie Preference Center