When you remove NetVault SmartDisk, the data in the Staging Store and the Chunk Store is retained after removal of the NetVault SmartDisk software binaries.
If you specified a different file-system path during installation, that is, you did not use the defaults, the data in the Staging Store and the Chunk Store is retained after removal of the NetVault SmartDisk software binaries.
1 |
Access Control Panel > Add or Remove Programs. |
2 |
In the preceding scenarios, the data in the NetVault SmartDisk Storage Pools is still intact and can be used by a new installation of the NetVault SmartDisk software binaries. Each NetVault SmartDisk installation of the software binaries creates a unique identity that is referenced in the NetVault SmartDisk Content Index and your backup product; therefore, it is critical that you use the following procedures to ensure that the new NetVault SmartDisk installation of the software binaries points to the original NetVault SmartDisk Storage Pools. Failure to follow these steps renders NetVault SmartDisk unable to read or restore from the original NetVault SmartDisk Storage Pools.
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Termini di utilizzo Privacy Cookie Preference Center