Corrected an erroneous completion status of Failed for restores of Server Databases when Domino Attachment and Object Service (DAOS) was configured. The error resulted from inclusion of the “daoscat.nsf” file in the backup process. Even if the “daoscat.nsf” file is visible in the selection tree for a Backup Set created using an earlier version of the plug-in, it is not included in the restore process. |
The conditions that lead to the abnormal termination of the nvnoteagent process without notifying the Lotus Domino Server have been reduced. This abnormal termination resulted in the following error message on Lotus Domino Server Console: Process <name> (<ID>) has terminated abnormally. However, not all causes have not been eliminated. Sporadic events might still occur. For details on removing the Lotus Domino Server Console message, see https://support.quest.com/. |
|
The plug-in does not currently support Lotus Domino Partition Servers. |
|
The plug-in name has been changed to use the “Plug-in for <product>” naming convention, that is, Plug‑in for Domino. If you upgrade the plug-in for a system that is managed by NetVault Backup Server 9.2, a consequence of the name change is that savesets created with the upgraded plug-in are not displayed in the NVBU Restore window when the Selection Method is set to Plugin; only savesets created with an earlier version are displayed. Workaround for NetVault Backup Server 9.2: On the Selections tab of the NVBU Restore window, select Job in the Selection Method list to view savesets or backups created with a previous version or the upgraded plug-in. |
DAOS configured on a Lotus Domino Server running on Linux/UNIX: When DAOS is configured for a Lotus Domino Server running on Linux or UNIX, cold backups and cold restores might fail with a message from the client that states: “Plug-in terminated unexpectedly” or “Plug-in is down.”
If you try the latter method and the “notes.ini” file does not have to be restored, edit the file again to change the DAOS_LOAD and DAOS_Enable settings back to 1 before you restart the Lotus Domino Server.
To change the DAOS_LOAD and DAOS_Enable settings from 1 to 0, edit the Lotus Domino Server’s “notes.ini” file, and try the backup again. After the backup has completed successfully, edit the “notes.ini” file again to change the DAOS_LOAD and DAOS_Enable settings back to 1 before you restart the Lotus Domino Server. |
Plug‑in for Domino 4.4 requires NetVault Backup 9.0 or later. For complete supported-platform information, see the Quest NetVault Backup Compatibility Guide.
© ALL RIGHTS RESERVED. Feedback Termini di utilizzo Privacy Cookie Preference Center