The changes that you make to the default multicast settings apply to all new multicast deployments.
You can change the multicast settings on a per deployment basis. Navigate to the Deployments page, and select the boot action to display the Automated Deployment Detail page, then click Show advanced settings.
1. |
On the left navigation pane, click Settings > Control Panel to display the Control Panel, then click Default Multicast Settings to display the Default Multicast Settings page. |
2. |
Change the Timeout to wait for connection 'Ready to receive' state for the duration that the appliance waits for all target devices to connect. The default is 10 minutes. |
3. |
4. |
5. |
If another device on your network is using port 2112, specify another port number in the Control channel port field. |
6. |
In the Multicast hops field, type the number of multicast hops over subnets. The default value is 1, but you can change it to suit your needs. |
7. |
8. |
If you want to revert to the settings included with the default installation, click Reapply factory settings. |
9. |
10. |
1. |
On the left navigation pane, click Progress, click Automated Deployments to display the Automated Deployment Progress page. |
2. |
3. |
1. |
2. |
3. |
If a task fails, you can edit the task from the device where it failed.
NOTE: The Client Task Error screen displays only on target devices with the Windows operating system. |
◦ |
Open a Command Prompt to run commands on the device. |
◦ |
Open Notepad to modify any file. |
◦ |
◦ |
Edit the Registry to change the OS configuration information. |
◦ |
Retry failed task to run the task again. |
◦ |
Resume task execution to continue the deployment with the failed task. |
◦ |
Reboot machine to restart the deployment. |
◦ |
Shut down machine to power off the device. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Termini di utilizzo Privacy Cookie Preference Center