To start or stop replication in an existing replication relationship, complete the following steps.
Using the or
toggle in the upper-right corner of the Replications pane, you may switch between tile and grid views.
To view more detailed information and additional options, click the elipsis icon .
|
NOTE: You can also set up replication schedules as needed. For more information see the topic, Configuring replication schedules. |
QoreStor gives you the ability to define user roles and assign users to those roles. A user can have more than one role. There are default user roles for the system as well.
QoreStor has the following types of user roles: CIFS, OST, RDA, Secure Connect, and Monitor. For the protocol specific user roles, the user is validated with the protocol credentials when the clients connect.
Refer to these important notes about user management in QoreStor.
To view the Users page, on the left navigation menu, click Users.
During the installation process, QoreStor creates two user accounts that simplify permissions and access to QoreStor configurations outside of the UI. Logging in with the qsadmin account provides direct access to the QoreStor command line, while the qsservice account provides direct access to the QoreStor Menu.
If these accounts are not needed, or if security protocols prohibit non-essential accounts, you may remove these accounts using the QoreStor Menu. To manage these accounts, navigate to the Remove QoreStor Account menu found at QoreStor Menu > Administration > Operating System > QoreStor User Management. Refer to Configuring QoreStor with the Configuration Menu for more information.
You can view user accounts and settings through either the QoreStor GUI or the command line interface.
To view users in the GUI, complete the following steps.
To view users using the command line:
user --show [--users] [--logins] [--verbose][--name <username>] [--roles <cifs|ost|rda|monitor|secureconnect>
Refer to the QoreStor Command Line Reference Guide for more information.
You can easily add users and assign them specific system roles by using either the QoreStor GUI or the command line interface. The system supports up to 64 users. Only one administrator account is supported.
To add a user through the GUI, complete the following steps.
To add a user through the command line, complete the following steps:
user --add --name <user name>
user --update --name <user name> [--add_roles <cifs|ost|rda|monitor|secure_connect>]
Refer to the QoreStor Command Line Reference Guide for more information.
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Conditions d’utilisation Confidentialité Cookie Preference Center