Tchater maintenant avec le support
Tchattez avec un ingénieur du support

NetVault Plug-in for SnapMirror to Tape 11.4.5 - User Guide

Installing the plug-in

Deploying the plug-in

The Plug‑in for SnapMirror to Tape supports the following deployment methods:


Before installing the plug-in, verify that the following requirements are met:

Install NetVault Backup Plug-in for NDMP (Plug-in for NDMP): Install Plug-in for NDMP on NetVault Backup Server if you are using a filer-to-filer setup and want to use the backup device attached to a different filer.
Install and configure NetApp SnapMirror: Install and configure the NetApp SnapMirror software on applicable NetApp filers.
Configure language and locale settings for NetVault Backup: Configure the correct language and locale settings on NetVault Backup WebUI. For more information, see the Quest NetVault Backup Administrator’s Guide.

Installing the plug-in

In the NetVault Backup Clients list, select the client on which you want to install the plug-in, and click Manage.
At the lower-right corner of the Installed Software table, click the Install Plugin button ().
Click Choose Plug-in File, and in the browse window, navigate to the location of the “.npk” installation file for the plug-in (on the installation CD or the directory to which the file was downloaded from the website).
Select the file named smt-x-x-x-x.npk (x-x-x-x represents the version, build, and platform numbers), and click Next to begin installation.
Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation