Tchater maintenant avec le support
Tchattez avec un ingénieur du support

NetVault Plug-in for Domino 4.4 - User Guide

Finalizing and submitting the job

The final steps include setting additional options on the Schedule, Source Options, and Advanced Options pages, submitting the job, and monitoring the progress through the Job Status and View Logs pages. These pages and options are common to all NetVault Backup Plug-ins. For more information, see the Quest NetVault Backup Administrator’s Guide.

1
To save the settings, click Ok, and then click Next.
2
In Job Name, specify a name for the job if you do not want to use the default setting.
Assign a descriptive name that lets you easily identify the job when monitoring its progress. The job name can contain alphanumeric and nonalphanumeric characters, but it cannot contain non-Latin characters. On Linux, the name can have a maximum of 200 characters. On Windows, there is no length restriction. However, a maximum of 40 characters is recommended on all platforms.
3
In the Target Client list, select the machine on which you want to restore the data.
* 
TIP: You can also click Choose, and then locate and select the applicable client in the Choose the Target Client dialog box.
4
Use the Schedule, Source Options, and Advanced Options lists to configure any additional required options.
5
Click Save or Save & Submit, whichever is applicable.
You can monitor progress on the Job Status page and view the logs on the View Logs page. For more information, see the Quest NetVault Backup Administrator’s Guide.
6
If you selected the DAOS node for the restore, review the documentation for your Domino Server to determine whether a resync operation, tell daosmgr resync, is required after the restore is complete.

Examples of restore sequences

The following examples describe the specific steps required to restore and recover data in different restore scenarios.

•
Restoring a Full Backup only
•
Applying Transaction Logs with a Full Backup
•
Restoring an Incremental Backup sequence

Restoring a Full Backup only

To restore a Full Backup without applying Transaction Logs, perform the following steps.

1
Select the data to restore.
For details, see Selecting data for a restore.
2
Configure the DAOS options, if necessary.
For details, see Configuring DAOS restore options.
3
Complete and submit the job.
For details, see Finalizing and submitting the job.

Applying Transaction Logs with a Full Backup

To apply Transaction Logs while restoring only a Full Backup, perform the following steps.

1
Select the data to restore.
For details, see Selecting data for a restore.
2
Click the Rollforward tab, and configure the Roll-Forward and PITR options.
•
If the Domino Server is online, select the Last Backup Set check box and the Soft Recovery option to apply the Transaction Logs on the server.
•
If the Domino Server is offline, select the Hard Recovery option.
For details, see Configuring Roll-Forward Recovery options and Configuring PITR options.
3
Configure the DAOS options, if necessary.
For details, see Configuring DAOS restore options.
4
Complete and submit the job.
For details, see Finalizing and submitting the job.
Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation