To upgrade the DR Series system software, complete the following:
1. |
Using the browser, go to support.dell.com, navigate to your DR Series product page, and enter your service tag. |
2. |
3. |
Locate the IDM section of the Drivers & Downloads page, which includes the Dell-Utility (DR Series Upgrade File) in the format, DR-UM-x.x.x.x-xxxxx.tar.gz, and showing its release date and version. |
4. |
5. |
Click Save to download the latest system software upgrade file to the DR Series system that is running the browser session started by the DR Series administrator. |
6. |
Using the DR Series system GUI, select Support, and click the Software Upgrade link (or select Support > Software Upgrade). |
7. |
Type the path of the software upgrade file in the Select the upgrade file from local disk (or click Browse..., and navigate to the location where you downloaded the system software upgrade file). |
9. |
When you initiate a DR Series system software upgrade, the navigation panel displays only the Support page and the Software Upgrade option.
There are only three possible outcomes during a DR Series system software upgrade operation:
◦ |
Upgrade has completed successfully—but a reboot is required (click Reboot in the Software Upgrade page). |
NOTE: If the DR Series system software upgrade operation fails, you can reboot the system and attempt another software upgrade operation using the DR Series system GUI. If this is unsuccessful, you can use the DR Series system CLI system --show command to view the current System State status. DR Series system software upgrades can also be performed using the DR Series system CLI. For details, see the Dell DR Series System Command Line Reference Guide at dell.com/support/manuals/. If both the DR Series system GUI and CLI attempts are unsuccessful, contact Dell Support for assistance. |
To install an SSL certificate, complete the following steps:
2. |
3. |
4. |
5. |
NOTE: If your browser cannot connect to a DR Series system after a certificate installation, you may need to reset the certificate from the command line interface (CLI) using “maintenance --configuration -- reset_web_certificate”. Refer to the Dell DR Series Command Line Reference Guide for more information. |
To reset an SSL certificate, complete the following steps:
2. |
NOTE: You can also use the command line interface (CLI) command, “maintenance -- configuration --reset_web_certificate”. Refer to the Dell DR Series Command Line Reference Guide for more information. |
© ALL RIGHTS RESERVED. Conditions d’utilisation Confidentialité Cookie Preference Center