To display the current usage for a DR Series system, complete the following:
2. |
View the current system usage based on the current Latest Range or Time Range values in effect (the default is the last 1-hour period). By default, the CPU Load is always the first tab that displays when the Usage page is selected. |
3. |
Click any of the system usage tabs to display the current status for that tab category (or click All to display all of the system usage tab results). |
To set a Latest Range value and display system status results based on this setting, complete the following:
2. |
3. |
4. |
Select a value in the Display last... drop-down list that matches the Range duration time period you selected. |
5. |
6. |
Click the tab that corresponds to the usage type you want to view based on the selected settings (or click All to display all of the system results based on the selected settings). |
To set a Time Range value and display system status results based on these settings, complete the following:
2. |
3. |
4. |
◦ |
Click Now to select the current date and time in Hours and Minutes (or use the Hour and Minute sliders to select a desired time value). |
5. |
6. |
In End Date, perform the same process that you did for setting the Start Date to specify an end date (or select Set “End Date” to current time). |
7. |
8. |
Click the tab that corresponds to the usage type you want to monitor using your choice of settings (or click All to display all of the system usage tab results based on your choice of settings). |
• |
Replication (if enabled) |
• |
Library/Slots/Access Control List (for VTL type containers only) |
For more information, see Editing Container Settings.
© ALL RIGHTS RESERVED. Conditions d’utilisation Confidentialité Cookie Preference Center