Tchater maintenant avec le support

Obtenir une aide instantanée
Terminer l’enregistrement

Se connecter

Demander les tarifs

Contacter le service des ventes

NetVault 13.3.2 - Installation Guide

Parcourir le contenu

About Quest® NetVault® About this document Target audience Recommended additional reading

Deploying NetVault

About deploying NetVault NetVault components Deployment planning

Reviewing pre-installation requirements

General requirements Platform-specific requirements

All Linux environments CentOS 7 Debian 8.x (64-bit) Debian 9.x (64-bit) Debian 12.x (64-bit) FreeBSD RHEL 7 RHEL 8 SLES 15 Ubuntu 18.04 and 20.4 Windows

Installing NetVault

Installation overview Installing NetVault in GUI mode Installing NetVault in text mode Installing NetVault in unattended mode Installing NetVault Client on Windows using Group Policy

Reviewing post-installation requirements

Platform-specific post-installation requirements

Upgrading NetVault

Upgrade requirements and considerations Preparing for an upgrade Upgrading NetVault in GUI mode Upgrading NetVault in text mode Upgrading NetVault in unattended mode Migrating NetVault Server from Hybrid to Pure environment

Migration Prerequisites Migrating NetVault Server in GUI mode Migrating NetVault Server in unattended mode Migrating NetVault Server from 32-bit OS to 64-bit OS

Upgrading licensed plug-ins

Licensing NetVault

About licensing NetVault Obtaining the machine ID Obtaining a permanent license file Installing the product license file

Removing NetVault

Removing NetVault Server or Client

Troubleshooting

NetVault Service fails to start on Windows NetVault Service fails to start after the machine is restarted NetVault Service starts, but stops immediately on Linux Installation aborted on Windows after installer fails to delete an existing directory Upgrade fails on a client running Plug-in for DB2

Debian 12.x (64-bit)

Note: Stop and restart NetVault service after installing NetVault 13.3.x Server or Client on Debian 12.

FreeBSD

Before installing NetVault 13.3.x Client on FreeBSD13.2, execute the following steps:

1

Add VM hostname and IP address entry in /etc/hosts.

2

Install the following package/s:

pkg install libiconv

RHEL 7

Before installing the pure 64-bit package of NetVault on RHEL 7 x86-64, install the following package:

RHEL 8

Before installing the pure 64-bit package of NetVault on RHEL 8 x86-64, install the following package:


	NOTE: For RHEL 7 and 8 version, if you do not have libglibmm library installed, you have to explicitly install it by executing following commands yum install glibmm24-devel. yum install libicu

Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation

© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Conditions d’utilisation Confidentialité Cookie Preference Center