Tchater maintenant avec le support
Tchattez avec un ingénieur du support

Foglight for DB2 (Cartridge) 7.2.0 - Getting Started Guide

Installation Procedures

Foglight for DB2 LUW runs on the Foglight Management Server, which is its operation framework. Therefore, Foglight Management Server must be installed before installing the cartridge. The installation of Foglight for DB2 LUW can be carried out using either of the following scenarios:

Installing Foglight for DB2 LUW as a cartridge from within an existing Foglight Management Server. For more information, see Installing the Foglight for DB2 LUW cartridge on a Management Server.

Installing Foglight for DB2 LUW using the executable installer

Installing Foglight for DB2 LUW using the executable installer

A single executable file allows installing Foglight Management Server together with Foglight for DB2 LUW.

Installing the Foglight for DB2 LUW cartridge on a Management Server

Installing the Foglight for DB2 LUW cartridge on a Management Server

Ensure that the pre-existing Foglight license that is being used allows cartridge installation. If a license that does not allow cartridge installation is used, the installation wizard cannot proceed beyond the Foglight Management Server License screen, which requires specifying the type of license to be installed.

To install Foglight for DB2 LUW as a cartridge:
3
In the browser interface, on the navigation panel, click Dashboards > Administration > Cartridges > Cartridge Inventory.
4
On the Cartridge Inventory dashboard, click Browse to find the car file on your local computer.
5
Click Install Cartridge.

Configuring Foglight for DB2 LUW

The next step is to configure agents to monitor your DB2 instances.

Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation