Tchater maintenant avec le support
Tchattez avec un ingénieur du support

Change Auditor for NetApp 7.2 - User Guide

Verify auditing template is applied

To ensure NetApp events are being captured, check to see if the agent assigned to the NetApp Auditing template is using the latest agent configuration.

1
Select Start | All Programs | Quest | Change Auditor | Change Auditor Client.
2
Open the Administration Tasks tab (View | Administration menu command).
4
Select Agent in the Configuration task list to open the Agent Configuration page.
5
Select the Change Auditor agent assigned to the NetApp auditing template (Auditing appears in the NetApp column) and click Refresh Configuration.

Make changes and run a report

2
Select Start | All Programs | Quest | Change Auditor | Change Auditor Client to review the events generated.
4
Expand the Shared | Built-in | All Events folder in the left pane.
5
Locate and double-click All NetApp Events in the right pane.

Troubleshooting steps

If the NetApp events do not appear as expected, check the following:

Verify that the NetApp filer is valid for the NetApp Auditing template. The NetApp Filer field should contain the NetBIOS name or IP address of the NetApp filer to be audited. The wizard does not validate this entry when it is entered.

 

NetApp Filer Auditing

Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation