Tchater maintenant avec le support
Tchattez avec un ingénieur du support

Change Auditor for NetApp 7.2 - User Guide

File System events settings

From the Agent Configuration page on the Administration Tasks tab you can view and/or modify the File System settings for handling duplicate events.

Use the File System tab at the top of the Configuration Setup dialog to define how to process duplicate file system events.

2
Click Configuration.
3
Select Agent in the Configuration task list to display the Agent Configuration page.
4
Click Configurations.
7
Once you have set these settings, click OK to save your selections, close the dialog and return to the Agent Configuration page.
8

NetApp event logging

In addition to real-time event auditing, you can enable event logging to capture NetApp events locally in a Windows event log. This event log can then be collected using InTrust to satisfy long-term storage requirements.

Event logging is disabled by default. When enabled, only configured activities are sent to the ChangeAuditor for NetApp event log. See the Change Auditor for NetApp Event Reference Guide for a list of the events that can be sent to the event log.

2
Click Configuration.
3
Select Agent in the Configuration task list to display the Agent Configuration page.
4
Click Event Logging.
6
Click OK to save your selection and close the dialog.

NetApp Searches/Reports

Introduction

You can create custom search definitions to search for file and/or folder changes to a specific NetApp file, folder or volume. You will use the Search Properties tabs across the bottom of the Searches page to define new custom searches.

 

Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation