The next step is to verify access and disk availability of the new or target NetVault Server.
1 |
From the NetVault WebUI, open the NetVault Selections page. |
3 |
4 |
When the “self” node is displayed, double-click it to display all disk device information for this NetVault Server. |
CAUTION: Even if there is no difference between the system devices in a backup and a restore, the order of the disks might be different. If the restored data is started without performing a rename, any data that exists on the disks is lost. To compare the information of the physical disk at backup and restore, note the Disk Geometry and Device Size at backup. For version 1.1.6 and later, also compare the Disk ID of the targeted disk on the Create Selection Set page to the Disk ID of the same disk on the NetVault Selections page. Quest strongly recommends that you disconnect all disks that contain critical data from the server before you boot NetVault Bare Metal Recovery for NetVault Server. |
• |
Ensure that device filenames match: The target device name on the NetVault Bare Metal Recovery Client, for example, Disk 0 (IDE), must be the same as it was at the time of backup. |
• |
Gather noted Device Size and Disk Geometry information: This information should have been noted before the backup. Have this information handy to complete the restore properly. |
1 |
In the Navigation pane, click Create Restore Job. |
2 |
3 |
5 |
Click Next. |
6 |
On the Create Selection Set page, select the data that you want to restore. |
© ALL RIGHTS RESERVED. Feedback Conditions d’utilisation Confidentialité Cookie Preference Center