Before recovering the NetVault Server, the following conditions must be met:
• |
In some instances, the Disk Number assigned to a drive during backup might be different for the restore. To work around this issue, note the Disk ID and disk order displayed on the Create Selection Set page, use the Plug-in Offline Client to boot the machine that is targeted for the restore, and then note whether the disk order is different. If the order is different, use the Rename option during the restore process to prevent data loss.
To determine whether the disk order is different, perform the following steps.
1 |
In the Navigation pane of the NetVault WebUI on the NetVault Server, click Create Restore Job. |
2 |
6 |
Use the Plug-in Offline Client to boot the NetVault Bare Metal Recovery for NetVault Server Client that is targeted by the restore, access the NetVault Server, and open the NetVault Selections page. |
1 |
Use the CD created in Booting into NetVault Bare Metal Recovery for NetVault Server to boot the server; if connected through a USB port, the port must use the 3.0 protocol or earlier. |
a |
In the NetVault Bare Metal Recovery Daemon process terminal (command prompt), press <Ctrl+C> to stop the process. |
b |
To open a new NetVault Bare Metal Recovery Daemon process terminal, double-click the Terminal icon on the desktop. |
1 |
In the Navigation pane of the NetVault WebUI, open the Manage Devices page. |
2 |
On the Manage Devices page, click the Manage Device icon for the drive or slot that contains the media that was used during backup, for example, BMRMedia, and is now marked “FOREIGN.” |
3 |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Conditions d’utilisation Confidentialité Cookie Preference Center