Tchater maintenant avec le support

Obtenir une aide instantanée
Terminer l’enregistrement

Se connecter

Demander les tarifs

Contacter le service des ventes

VERSIONS D'ESSAI GRATUITES

QoreStor 6.1.0 - VM Deployment Guide

Parcourir le contenu

About the QoreStor VM Deployment Guide

Other information you may need

Getting started

Introducing QoreStor QoreStor VM Specifications NIC drivers and settings

Hyervisor host NIC driver updates for VMQ

Evaluating QoreStor

Evaluating QoreStor on Oracle VirtualBox Evaluating QoreStor on VMware Workstation Evaluating QoreStor on Microsoft Hyper-V Evaluating QoreStor on VMware ESXi

Deploying QoreStor on VMware ESXi

Deploying the QoreStor using the vSphere Web Client

Deploying QoreStor on Microsoft Hyper-V

Prerequisites for deploying QoreStor in Microsoft Hyper-V 2012 R2 environments Prerequisites for deploying QoreStor in Microsoft Hyper-V Server 2016 and environments

Prerequisites for deploying QoreStor in Microsoft Hyper-V Server 2016 and environments

Deploying QoreStor on a local Microsoft Hyper-V host Changing the storage paths for Hyper-V deployment

Setting up and Configuring QoreStor

Initial login and changing your password Initial network configuration Using the QoreStor Menu QoreStor Administration QoreStor Maintenance QoreStor Statistics Storage resizing Additional configurations Adding a Performance Tier

Repairing your virtual machine

Configuring the DR2000v

The following steps describe how to set up and configure QoreStor for the first time.

After deploying QoreStor, wait for the virtual appliance to boot completely. It takes approximately 10-20 minutes to self-extract the installation package and all of the components.
Log on to the QoreStor virtual machine (VM) console using the default Username: qsservice and Password: changeme.
The QoreStor Menu is displayed.
On the Initial System Configuration Wizard screen, type yes and press <Enter> to finish the Initial System Configuration on network settings.
Follow through the wizard to configure the required network entries and confirm the configuration settings.

NOTE:

If DHCP configuration is used, all of the entries are done automatically.
If Static IP configuration is used, all of the entries must be entered manually.

After the required network settings are configured, the VM will run the initial configuration, which may take up to 3-4 minutes to complete.

Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation