Tchater maintenant avec le support

Obtenir une aide instantanée
Terminer l’enregistrement

Se connecter

Demander les tarifs

Contacter le service des ventes

Change Auditor for Authentication Services 7.1.1 - User Guide

Parcourir le contenu

Quest Change Auditor for Authentication Services Overview

Introduction Change Auditor for Authentication deployment requirements

Getting Started

Deployment requirements Enable Authentication Services auditing Enable and disable events as required Make changes and run a report

Authentication Services Searches/Reports

Introduction Authentication Services built-in reports Create custom searches Search results

Search results

The event information (including key information like who, what, when, where, why, the event origin, and the file information) can be viewed on the Event Details pane.

Table 1. Event Details pane: Authentication Services events
ChangeAuditor	Description
Severity	Displays “Low”, “Medium”, or “High” depending on the event.
Who	Specifies the name of the user who initiated the change.
When	Specifies the date and time when the change occurred.
Where	Displays the name of the workstation where the change occurred.
Source	Displays ‘Change Auditor’ which is the application from which the event was retrieved.
Origin	Displays the NetBIOS name and IP address of the workstation from which the event was generated.
What	Displays a description of the activity that occurred. NOTE: For lengthy descriptions, hover your cursor over the description field to view the entire event description.
Facility	Displays that it is Authentication Services Monitoring activity.

Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation

© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Conditions d’utilisation Confidentialité Cookie Preference Center