DL Appliance will not boot due to UEFI error messages UEFI0004 and UEFI0116 (4041692)

Tchater maintenant avec le support

Obtenir une aide instantanée
Terminer l’enregistrement

Se connecter

Demander les tarifs

Contacter le service des ventes

Retour

Commentaire envoyé

Cet article vous a-t-il à résoudre un problème ?

Sélectionner une évaluation

Titre

DL Appliance will not boot due to UEFI error messages UEFI0004 and UEFI0116
Description

The following error messages are displayed during the boot up process and it hangs in the middle of it:
Error Message 1
A system restart is required.
The system detected an exception during the UEFI pre-boot environment.
Type: Invalid opcode (06) Source: Software (UEFI0004)
Error Message 2
Avago EFI SAS Driver: Unhealthy status reported by this UEFI driver without specific error message(s). UEFI0116: One or more boot drives have reported issue(s). Check the Driver health menu in boot manager for details.
Cause

Based on the hardware OEM vendor documentation related to the error code UEFI0004 and CPU Exception Type 0x06: Invalid Opcode (Software) this could happen due to several reasons, but on this specific issue the BIOS Boot mode was set to BIOS as expected on the DL Appliance by default, so the next items to discard on the list are the ones listed below on Recommended Response Action.

Detailed Description
A CPU invalid opcode exception (type 0x06) occurred in the pre-boot UEFI environment. The software attempted to execute invalid code.
Recommended Response Action
Recently installed hardware or updated software may cause this exception. Update or remove the hardware or software.
Category
System Health (UEFI = UEFI Event)
Severity
Severity 1 (Critical)
Résolution
1. Open the BIOS Settings > Boot Settings and validate if the Boot Options and Hard-Disk Drive Sequence looks correct, which means the internal PERC H730 Mini is being displayed as the first boot device. (see screenshot below for reference)
2. If everything looks correct from step 1, open the iDRAC console and review the LifeCycle logs looking for possible device errors, as for example, on the case study shown on the below screenshots the issue was happening due to a faulty PERC H830 (external for expansion enclosures) installed on slot 3-1. Try installing the Device on any other compatible PCI-E slot and see if the issue continues, if it does, continue with the next step.
3. Remove the device that is showing the error message and is no longer being detected, try to boot up the server again and if it works this time, continue with next step.
4. Upgrade the following software on the following hardware components on the DL Appliance Server (PE R730xd):
  - BIOS
  - Lifecycle Controller/iDRAC
  - On the case study showing issues with the PERC H830 we updgraded the PERC H730 Mini Driver(same package as H830) and the firmware as well.
  - Upgrade the firmware or driver of any other device showing errors from the Lyfecycle Controller (hardware) logs.
5. After the updates were applied, reinstall the device that was previously removed on step 3 and the system should boot just fine, however if the issue persists it is possible that a hardware replacement is needed, please contact support and we will be more than glad to assist you fix it.