About event monitoring configurations
The configurations for event monitoring are done by way of the configuration file for the Quest vRanger Service, Vizioncore.vRanger.Service.exe.config. This file is located in the vRanger installation directory. The default is C:\Program Files\Quest\vRanger.
Opening the configuration file
Complete the steps in the following procedure to open the configuration file.
To open the configuration file:
1 Open the Vizioncore.vRanger.Service.exe.config file with your text editor of choice.
Configuring replication monitoring
Replication monitoring logs replication task failures to the Windows® event log with the Event ID of 10001. The log also includes the error message and information about the task such as source VM, target host, and vCenter.
To configure replication monitoring:
1 In the Vizioncore.vRanger.Service.exe.config file, scroll to line 162 or search for Replication FailureWriteEventLog.
2
Configuring virtual appliance (VA) monitoring
To configure VA monitoring:
1 In the Vizioncore.vRanger.Service.exe.config file, find the lines corresponding to the preferred setting:
▪ VirtualApplianceMonitoringEnabled: line 204.Set this value to “true” to enable monitoring of the VA.
▪This value determines how often the refresher message occurs for a failed VA check after the FailureLogMax value has been reached. The default is 6, which indicates that it logs an event every six hours.
This setting determines how often vRanger checks the connection to configured VAs. The default is 5, which indicates that it checks the connection every five minutes.
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. 使用条款 隐私 Cookie Preference Center