Chat now with support
Chat mit Support

NetVault Plug-in for SnapMirror to Tape 10.0.5 - User Guide

Adding a NetApp filer

1
In the Navigation pane, click Guided Configuration, and then on the NetVault Configuration Wizard page, click Create Backup Jobs.
2
Click Create New next to the Selections list to open the NetVault Backup Selections page.
3
Open the NetVault Backup Server. Select NDMP SnapMirror to Tape, and in the Actions list, click Add Server.
4
In the NDMP Server dialog box, configure the following settings.
Set the configuration option Codepage for UTF-8 Conversions for the Plug‑in for SnapMirror to Tape. For more information, see Configuring default settings.
NOTE: For NetApp filers, the actual conversion is specified on a per-job basis by setting plug-in option Request Unicode File Information. However, the Use UTF-8 Conversions check box must be selected to use this feature.
5
Click OK to add the filer.

Editing server details

1
Start the Backup Job Wizard, and click Create New next to the Selections list.
3
Select the filer, and in the Actions list, click Edit Server.
To change the password, select the New Password check box, and type the password.
5
Click OK to save the new settings.

Removing a server

1
Start the Backup Job Wizard, and click Create New next to the Selections list.
3
Select the filer, and in the Actions list, click Remove Server.

Configuring NetVault Backup user account

1
Start the Backup Job Wizard, and click Create New next to the Selections list.
3
Select the filer, and in the Actions list, click Set Account.
4
In the NetVault Account dialog box, provide the following information:
Account: Type “default”, which is the user account used to run subjobs.
New Password: Select the New Password check box, and specify the password for the “default” account.
5
Click OK to save the information.
Verwandte Dokumente

The document was helpful.

Bewertung auswählen

I easily found the information I needed.

Bewertung auswählen