Chat now with support
Chat with Support

MessageStats 7.8 - Report Pack for Outlook Web Access (OWA) User Guide

Configuring the ISA Server

Once you have configured RPC to use a specific set of ports on the Exchange server, you must make those ports available to the MessageStats server. You do this by opening the required ports on the firewall.

In addition to opening the dynamically-assigned ports, you also must open port 135. Port 135 provides access to the RPC Endpoint Mapper. The port must be available for proper operation of RPC.

Opening the proper ports on an ISA server
1
Open the ISA Server Management console.
2
Select the Firewall Policy node for your OWA server.
3
Under the Action menu, select New/Access Rule.
4
Enter a name for your access rule (for example, MessageStats RPC).
5
Click Next.
6
Select the Allow option and click Next.
7
On the Protocols page, add the RPC (all interfaces) protocol.
Make sure you do not add the RPC Server (all interfaces) protocol.
8
Create a new protocol for the range of RPC ports to be used. Set the protocol properties as follows:
•
Protocol Type - TCP
•
Direction - Outbound
•
Port Range - 5000 to 5100
9
Add the newly created protocol type and click Next.
10
In the Access Rule Sources page, add the Internal network.
- OR -
Define the MessageStats server as a network identity and add it.
11
Click Next.
12
In the Access Rule Destinations page, add the Exchange server.
- OR -
Add Local Host if the ISA Server software is installed on the Exchange server.
13
Click Next.
14
On the User Sets page, click Next.
15
Click Finish to close the wizard and create the access rule.
16
In the console, click Apply to apply your changes.
Related Documents

The document was helpful.

Select Rating

I easily found the information I needed.

Select Rating