1 |
In the Navigation pane, click Create Backup Job. |
2 |
In Job Name, specify a name for the job. |
3 |
In the Selections list, select an existing Backup Selection Set, or complete the following steps to create a set. |
a |
b |
c |
To display the Volumes node, open the applicable filer in the list of added servers. |
• |
Back up all volumes: Select the Volumes node. |
• |
Back up individual volumes: Open the Volumes node, and select the volumes that you want to back up. |
NOTE: In NetApp ONTAP 8.x C-Mode, you cannot open the Volumes node to browse or select the contents. However, you can specify a single data path for a backup. For more information, see Backing up individual data paths in C-mode. |
4 |
In the Plugin Options list, select an existing Backup Options Set, or complete the following steps to create a set. |
a |
• |
NDMP Backup Options: For more information about these options, see NDMP Backup Options |
c |
d |
In NetApp ONTAP 8.x C-Mode, you cannot open the Volumes node to browse or select the contents. However, you can specify a single data path for a backup.
1 |
In the Navigation pane, click Create Backup Job. |
2 |
In Job Name, specify a name for the job. |
3 |
4 |
5 |
6 |
7 |
Set the Dump Level and the remaining backup options. |
1 |
In the Navigation pane, click Create Restore Job. |
Displays savesets created for particular clients. The default selection is Any.
| |||||
Displays savesets created using a particular plug-in. The default selection is Any.
| |||||
Displays savesets created during a specified period. The default selection is Any.
| |||||
Displays savesets created for particular jobs. The default selection is Any.
|
4 |
On the Create Selection Set page, select the data that you want to restore: |
• |
Restore entire saveset: Select the root node. |
• |
Restore individual files and directories: Select the target files and directories in the selections tree. The selections tree can only be browsed if the Save File Information option was selected during backup. |
NOTE: While restoring data from a snapshot backup, you must use the Relocate option. If you do not use this option, the restore job fails. The Relocate option allows you to relocate data to the same or a different volume. For more information about relocating data, see Renaming or relocating data. If you omit child-level items after selecting the parent node, the job fails. To perform selective restores, open the parent node, and select each item that you want to restore. |
5 |
Click Edit Plugin Options, and configure the following settings. |
Select the appropriate Direct Access Restore (DAR) mode from the following:
| |||||||||
This option is equivalent to setting the environment variable EXTRACT=N. The plug-in overwrites the existing files and deletes the files that were not present at the time of backup. | |||||||||
To restore ACLs from the backed-up file, select this option. This option is equivalent to setting the environment variable EXTRACT_ACL=Y. You can use this option only if the Backup ACLs option was selected during backup. |
6 |
7 |
In Job Name, specify a name for the job. |
9 |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. 利用規約 プライバシー Cookie Preference Center