サポートと今すぐチャット
サポートとのチャット

NetVault Bare Metal Recovery 10.5 - Release Notes for NetVault Backup Server

Resolved issues

The following is a list of issues addressed in 10.5, Revision 1.
 
Table 2. General resolved issues
Resolved issue
Issue ID

Replaced glibc-2.12-1.149.el6_6.9.x86_64 with glibc-2.12-1.166.el6_7.7.x86_64 to eliminate security vulnerabilities (CVE-2015-5229 and CVE-2015-7547).

30838

Known issues

The following is a list of issues, including those issues attributed to third-party products, known to exist at the time of release.
 
Table 3. General known issues
Known issue
Issue ID

When NetVault Bare Metal Recovery for NetVault Backup Server backup jobs have a status of “Waiting for Media” over an extended period, it might cause subsequent jobs to fail. These failures include Index Conflict errors after additional media items are made available to NetVault Backup and multiple previously scheduled jobs are run simultaneously.

360

If you perform a recovery using VaultOS and it is installed on a device connected to the machine through a USB port, the port must use the 2.x protocol or earlier. VaultOS does not support the 3.x protocol.

26384

System requirements

Before installing NetVault Bare Metal Recovery for NetVault Backup Server 10.5, ensure that your system meets the following minimum hardware and software requirements.

Upgrade and compatibility

•
For complete supported-platform information, see the Dell NetVault Backup Compatibility Guide.
•
NetVault Bare Metal Recovery for NetVault Backup Server is available as a separate download and is a specially-packaged version of NetVault Bare Metal Recovery that provides offline, bare metal protection for NetVault Backup Servers running on x86/x86-64-based operating systems that use locally-attached tape-based devices. The Bare Metal Recovery image of the NetVault Backup Server is taken by a LiveCD that is preloaded with a NetVault Backup Server, the NetVault Bare Metal Recovery Plug-in Server, and the drdaemon process. The Bare Metal Recovery image can then be transferred to a direct-attached tape-based library or standalone tape drive for recovery in case disaster recovery is required.
•
The preloaded NetVault Backup Server uses NetVault Backup 10.0.0. However, this preloaded version of the NetVault Backup Server can protect and recover NetVault Backup Servers and Heterogeneous Clients running NetVault Backup 8.2.2 and later.

The document was helpful.

評価を選択

I easily found the information I needed.

評価を選択