サポートと今すぐチャット
サポートとのチャット

NetVault Plug-in for Oracle 10.0.5 - User Guide

Introducing Dell™ NetVault™ Backup Plug-in for Oracle® Defining a backup strategy Installing and removing the plug-in Configuring the plug-in Backing up data Using the Oracle® Flashback Database Restoring data
Restoring and recovering data: an overview Performing User Managed restores Using advanced User Managed restore procedures Performing RMAN restores Using RMAN types of recovery in a non-RAC environment Using advanced procedures with RMAN restores
Maintaining the Recovery Catalog Using the RMAN CLI Using the Plug-in with Oracle® RAC Using the Plug-in in a failover cluster environment Using the plug-in with Oracle® Data Guard Troubleshooting Glossary

Flashback Database: an overview

Introduced in Oracle® 10g, Flashback Database lets you rewind an Oracle database to a previous time to correct problems caused by logical data corruptions or user errors as long as the datafiles are intact. Flashback Database is not true media recovery because it does not involve restoring physical datafiles. Flashback Database is preferable to using the RESTORE and RECOVER commands in some cases because it is faster and easier and does not require restoring the whole database.
For more information on Flashback Database, see Configuring Oracle Flashback Database and Restore Points in the Oracle Database Backup and Recovery User’s Guide.

Viewing Flashback Database status

1
In the Navigation Pane, click Create Backup Job, and click Create New next to the Selections list.
3
Double-click Plug‑in for Oracle, and select the applicable database.
4
From the Actions list, select View Details.
Flash Recovery Area Destination: When FRA is enabled, this option displays the destination of the FRA.
Flashback Database Enabled: Indicates YES if the Flashback Database feature is enabled or NO if not.
Additionally, backups done with plug-in show a Flashback Database node for the plug-in on the Create Selection Set page when you create a restore job. The Flashback Database node lets you perform a Flashback Database instead of a restore or recovery.

Flashback Database options

To Restore Point: Flashes the database to a specific restore point. A restore point is a named point that can be used as a flashback target. When you create a restore point, you are naming the current System Change Number (SCN). You can create up to 2048 named restore points and these points can either be normal or guaranteed. A guaranteed restore point is used in a Flashback Database.
Restore points can be created using the CREATE RESTORE POINT command. For more information, see Creating Normal and Guaranteed Restore Points in the Oracle® Database Backup and Recovery User’s Guide.
To Time: Reverts the database back to its state at the time specified.
To SCN: Reverts the database back to its state at the specified SCN.
Before Time: Reverts the database back to its state one second before the specified timestamp.
Before SCN: Reverts the database back to its state at the system change number just preceding the specified SCN.
Before Reset Logs (available for Oracle® 10.2.x and later versions only): Rewinds the database back to the SCN just before the RESETLOGS happened.

Flashback Database restrictions

On the Create Selection Set page, Flashback Database cannot be selected at the same time as other nodes such as Parameter File, Control Files, Tablespaces, and Datafiles. If selected, the restore job fails and the NetVault Backup binary logs show an error message:
関連ドキュメント

The document was helpful.

評価を選択

I easily found the information I needed.

評価を選択