1 |
In the Navigation pane, click Manage Devices. |
3 |
Click Configure. |
4 |
In the Edit Drive dialog box, configure the settings in the following tabs: |
• |
NDMP Configuration: The NDMP parameters are available here. The default settings for any parameter on this tab must not be changed unless otherwise advised by Quest Support. For more information about these settings, see NDMP settings. |
• |
Configuration: Set the required parameters here.The default settings for any parameter on this tab must not be changed unless otherwise advised by Quest Support. For more information about these settings, see General settings for tape drives. |
• |
Performance: For more information about these settings, see Drive performance settings. |
• |
Statistics: For more information about these settings, see Statistics collection settings. |
• |
SCSI Configuration: The default timeout value for the different types of SCSI commands is set to zero, which correspond to the following intervals: |
• |
Generic Cleaning: To configure generic cleaning settings for a tape drive, select this option. For more information about these settings, see Generic cleaning settings. |
5 |
Click OK to save the settings and close the dialog box. |
The following table provides examples of the optimal values that can be used for some drive types.
1 |
In the Navigation pane, click Manage Devices. |
3 |
1 |
In the Navigation pane, click Manage Devices. |
3 |
• |
If the device is offline, click Online to bring it back online. |
• |
If the device is online, click Offline to mark it offline. |
© ALL RIGHTS RESERVED. 利用規約 プライバシー Cookie Preference Center