NetVault 13.0.3 - Administration Guide

Deployment task fails due to network configuration issues.

Deployment task fails on the remote target machine due to network configuration issues.

Task logs displays an error message:

Not able to find any valid IP address for NetVault server. Make sure valid n/w configurations are in place.

Check the network configuration and then run the command hostname -i on the target machine.Check if all the valid IP address are listed and not the Loopback address.

Domain user is unable to login NetVault Server if the workstation attribute is set.

Domain user is unable to login NetVault Server with correct credentials.

Following log messages are displayed on Linux and Windows based NetVault Server, respectively:

On domain controller, check the workstation attribute of the domain user.

Domain user is unable to login NetVault Server on Debian 9.

Domain user is unable to login NetVault Server on Debian 9.

NetVault Server displays following error in the nvavp-*.log log file:

Domain user validation failed due to access restrictions

Even after successful authentication, authorization is denied due to Group Policy Object Settings.

Set below parameters to resolve this issue in /etc/sssd/sssd.conf configuration file:

access_provider = ad

auth_provider = ad

ad_gpo_access_control = permissive.

Adding the target machine as a client fails, after successful push installation.

Push installation succeeds on the target machine, however adding the machine as client fails with warning.

Adding a new client on the target machine fails with a warning message, after successful push installation of a remote client target machine.

While adding the machine as a client on the target machine, following warnings are displayed in task logs,

NetVault Server is unable to contact NetVault Client on the target machine due to firewall configurations. Configure the firewall on the target machine to add the machine as a client. For more information, see, Quest NetVault Administrator’s Guide.