サポートと今すぐチャット
サポートとのチャット

NetVault 13.0.2 - CLI Reference Guide

Introduction Getting started Using the command-line utilities Using the nvreport utility

nvclientaccess

Grants access to specified NetVault Clients.

-client or -clients

Specifies the names of NetVault Clients to which access is granted.

-tdclients

Specifies the name of the Teradata DBS. You can use this option to grant access to all added clients.

-password

Specifies NetVault password of the client. This option is required if security is enabled on the client.

nvclientadd

Adds a single NetVault Client to the server. You must run this utility on the NetVault Server.

-client

Specifies NetVault name of the client that you want to add.

-clientip

Specifies IP Address of the NetVault Client that you want to add.

-clientgroup

Specifies the name of the client group to which you want to add the client. Verify that the client group is created before you add the client.

-password

Specifies NetVault password of the client. This option is required if security is enabled on the client.

-timeout

Specifies the amount of time NetVault waits for the client to approve the “add” request. The timeout value is specified in minutes. If a client cannot be added within the specified period, an error message is displayed

-version

Displays build date of the NetVault distribution installed on the machine.

To locate a client that is unavailable, use the nvclientlist -find <ipaddress> command. For more information, see nvclientlist.

nvclientlist

Performs the following functions:

Table 6. nvclientlist

-current

Lists clients that are currently added to the NetVault Server.

-available

Lists available NetVault machines that can be added as clients.

-name

Specifies NetVault name of the client that you want to locate.

-find

Specifies the resolvable name or IP address of the machine that you want to locate.

-version

Displays build date of the NetVault distribution installed on the machine.

nvclientname

Allows you to rename a NetVault Client. You cannot use this utility to change the name of a NetVault Server.

Table 7. nvclientname

-clientname

Specifies the new NetVault name for the client.

関連ドキュメント

The document was helpful.

評価を選択

I easily found the information I needed.

評価を選択