Before you start the restore procedure, verify that the following requirements are met:
• |
Add a backup device to the NetVault Backup Server. For more information about this procedure, see the Quest NetVault Backup Administrator’s Guide. |
• |
1 |
In the Navigation pane, click Create Restore Job. |
3 |
On the Create Selection Set page, select the database components to recover the full database or parts of it. |
4 |
• |
Blank reports database tables before restore: By default, the existing data in the reports database is deleted when you restore the NetVault Database. If you want to retain the existing data in the reports data, clear this check box. |
6 |
On the Create Restore Job page, specify a name for the job. Assign a descriptive name that allows you to easily identify the job for monitoring its progress. |
7 |
In the Target Client list, the client from which data was backed up is selected by default. Do not change this setting. |
8 |
Select or create the Schedule Set, Restore Source Set, and Advanced Options Set. For more information about these sets, see the Quest NetVault Backup Administrator’s Guide. |
9 |
Click Submit to submit the job for scheduling. |
NOTE: To ensure that the catalog search and postgres databases are in sync after NVDB restore, you must select the “Add pre-existing backups to catalog” option on the Catalog Search Configuration page. |
The procedure for backing up raw devices includes the following steps:
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback 利用規約 プライバシー Cookie Preference Center