To delete an existing diagnostics log file from the Diagnostics summary table on the Diagnostics page, complete the following:
2. |
3. |
Click OK to delete the selected diagnostics log file (or click Cancel to display the Diagnostics page). |
When you initiate a DR Series system software upgrade, the navigation panel displays only the Support page and the Software Upgrade options.
The administrator that initiated the software upgrade (considered the initiator administrator) will see a System Information pane that displays an alert that reads IMPORTANT: Please do not navigate out of this screen until the upgrade is finished, and displays the upgrade status as Upgrade in Progress... Please wait.... The Current Version and Upgrade History versions of the DR Series system software are listed in the Software Info pane.
All other administrators that may be logged into DR Series system (with the exception of the initiator administrator who started the software upgrade), will only see a dialog that displays Status: The system is being upgraded. Wait for it to become operational.
There are only three possible outcomes during a DR Series system software upgrade operation:
• |
The upgrade operation completed successfully—but a reboot is required (click Reboot in the Software Upgrade page). |
Use the Software Upgrade page to verify the current installed version of the DR Series system software in the Software Information pane, or to apply updates to the system. There are two methods you can use to display the Software Upgrade page:
• |
• |
Both methods display the Software Upgrade page where you can verify the current installed version, check the upgrade history of previously installed software versions, verify the iDRAC IP address (if one is in use), start the upgrade process, or reboot the DR Series system using the options on this page.
To verify the currently installed version of the DR Series system software, complete the following:
NOTE: You can verify the version of the installed DR Series system software in the Dashboard page (in the System Information pane), the Support page (in the Support Information pane), and the Software Upgrade page (in the Software Information pane).
|
1. |
In the navigation panel, select Support and click Software Upgrade (or select Support→ Software Upgrade). |
2. |
Verify the currently installed DR Series system software version listed as Current Version in the Software Information pane (all previously installed versions are listed under Upgrade History, showing the version number and timestamp when installed). |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Conditions d’utilisation Confidentialité Cookie Preference Center