Tchater maintenant avec le support
Tchattez avec un ingénieur du support

NetVault Plug-in for Oracle 10.0.5 - User Guide

Introducing Dell™ NetVault™ Backup Plug-in for Oracle® Defining a backup strategy Installing and removing the plug-in Configuring the plug-in Backing up data Using the Oracle® Flashback Database Restoring data
Restoring and recovering data: an overview Performing User Managed restores Using advanced User Managed restore procedures Performing RMAN restores Using RMAN types of recovery in a non-RAC environment Using advanced procedures with RMAN restores
Maintaining the Recovery Catalog Using the RMAN CLI Using the Plug-in with Oracle® RAC Using the Plug-in in a failover cluster environment Using the plug-in with Oracle® Data Guard Troubleshooting Glossary

Editing database information

To reconfigure the database details:
1
In the Navigation Pane, click Create Backup Job, and click Create New next to the Selections list.
2
In the selection tree, open the applicable client node, and double-click Plug‑in for Oracle.
3
Click the name of the applicable database to highlight it (do not select the check box).
4
From the Actions list, select Edit Database.
The Edit Oracle Database dialog box displays configured values for the database instance.
5
Reconfigure the parameters as required.
For information on the fields in this dialog box, see Adding a database.
6
To save the changes, click OK.
 
* 
IMPORTANT: The password fields on the Edit Oracle Database dialog box are blank. You must set the passwords again (even if there are no changes). If this step is not done, the existing values are reset to blank when you save the updated information. To update only the authentication details for the plug-in, select the Set Database Password option instead of Edit Database.

Setting the database password

Plug‑in for Oracle lets you save the Oracle® authentication details that are used to connect to the database automatically. Saving the authentication information eliminates the need to enter the details each time a connection to the database is required. You can save these details either at the time of adding a database or any time later using the Set Database Password option.
To set the authentication details for an added database:
1
In the Navigation Pane, click Create Backup Job, and click Create New next to the Selections list.
2
In the selection tree, open the applicable client node.
3
Double-click Plug‑in for Oracle, and select the applicable database.
4
From the Actions list, select Set Database Password.
5
Enter the following information:
•
Account Name: Enter an Oracle user name with SYSDBA privileges.
•
Password: Enter the password associated with the name specified in the preceding field.
6
To save the settings, click OK.
 
* 
IMPORTANT: If the password for the configured SYSDBA user is changed in the Oracle database, you must update the password in the plug-in.

Removing a saved password

To remove the saved password for a database:
1
In the Navigation Pane, click Create Backup Job, and click Create New next to the Selections list.
2
In the selection tree, open the applicable client node.
3
Double-click Plug‑in for Oracle, and select the applicable database.
4
From the Actions list, select Remove Saved Password.
5
When the Reset Login dialog box appears, click Yes to clear the authentication details.

Removing a database

If a previously configured database is no longer in use, you can remove it from the plug-in.
To remove a database:
1
In the Navigation Pane, click Create Backup Job, and click Create New next to the Selections list.
2
In the selection tree, open the applicable client node.
3
Double-click Plug‑in for Oracle, and select the applicable database.
4
From the Actions list, select Remove Database.
5
When the Remove Oracle Database dialog box appears, click Yes to remove the database.
Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation