You can configure default settings for various built-in and licensed plug-ins from the Change Settings or Create Backup Job page. The plug-in configuration procedures are covered in the respective user guides.
This section includes the following topics:
The Disk Devices Plug-in is used to create Virtual Tape Libraries (VTLs). You can configure default settings for this plug-in from the Change Settings page.
1 |
In the Navigation pane, click Change Settings. |
• |
To configure default settings for the NetVault Server, go to Step 3. |
• |
To configure default settings for a NetVault Client, click Clients. In the NetVault Clients table, select the client, and click Next. |
3 |
4 |
5 |
Click Apply to apply the new settings and close the dialog box. |
By default, the nvjobstart command returns either 0 or 1 (0 to indicate success, and 1 to indicate failure). You can configure the utility to return enhanced job completion status codes and messages that indicate the way in which a job failed.
1 |
In the Navigation pane, click Change Settings. |
• |
To configure default settings for the NetVault Server, go to Step 3. |
• |
To configure default settings for a NetVault Client, click Clients. In the NetVault Clients table, select the client, and click Next. |
3 |
4 |
• |
nvjobstart Enhanced Job Completion Status: By default, the nvjobstart utility returns the following messages depending on the job exit codes. |
Job failed with error: ‘Job Failed’ This message is returned for the following job completion states:
|
NOTE: You must configure this option on the NetVault machine on which you run the nvjobstart utility. |
5 |
Click Apply to apply the new settings and close the dialog box. |
1 |
In the Navigation pane, click Change Settings. |
• |
To configure default settings for the NetVault Server, go to Step 3. |
• |
To configure default settings for a NetVault Client, click Clients. In the NetVault Clients table, select the client, and click Next. |
3 |
4 |
In the Script dialog box, configure the following setting: |
• |
Terminate running script on Job Abort: This check box is selected by default. If you want to continue script execution even when the associated job is aborted, clear this check box. |
5 |
Click Apply to apply the new settings and close the dialog box. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Conditions d’utilisation Confidentialité Cookie Preference Center