Tchater maintenant avec le support
Tchattez avec un ingénieur du support

Change Auditor 7.4 - Release Notes

Getting started with Change Auditor 7.4

•
Upgrade and compatibility
•
Additional resources
•
 

Upgrade and compatibility

You can upgrade to Change Auditor 7.4 from the following versions of Change Auditor: 6.x through 7.x.

•
For versions prior to 6.8: You can upgrade directly to 7.4. If the upgrade cannot proceed because 5.x events are still present in the database, upgrade to 6.8 first to complete the upgrade of the 5.x events, then upgrade to 7.4.
•
Previous versions of Change Auditor agents (6.x through 7.x) can connect and work with the new Change Auditor coordinator.
•
Change Auditor 7.2 and later agent requires Microsoft .NET Framework 4.7.1. See the Change Auditor agent (Server-side component) system requirements for the list of supported platforms.
•
Change Auditor 7.0.2 and higher agents cannot connect to a coordinator version 7.0.1 or earlier. When upgrading the Change Auditor agent to 7.0.2 and higher, ensure the Change Auditor coordinator has also been upgraded to 7.0.2 and higher.
•
An Azure Web application with Microsoft Graph API permissions is required to audit Office 365 and Azure Active Directory. As a result, when updating from Change Auditor 7.0.3 or earlier, any existing Office 365 or Azure Active Directory auditing templates must be updated by the Change Auditor administrator. See the Office 365 and Azure Active Directory auditing User Guide for details on updating the templates and the required permission.

Additional resources

* 
NOTE: For installation and upgrade procedures, refer to the Change Auditor Installation Guide.

Additional information is available from the following:

•
Online product documentation (https://support.quest.com/change-auditor/technical-documents)
•
Quest Community (https://www.quest.com/community/change-auditor)

Globalization

This section contains information about installing and operating this product in non-English configurations, such as those needed by customers outside of North America. This section does not replace the materials about supported platforms and configurations found elsewhere in the product documentation.

This release is Unicode-enabled and supports any character set. In this release, all product components should be configured to use the same or compatible character encodings and should be installed to use the same locale and regional options. This release is targeted to support operations in the following regions: North America, Western Europe and Latin America, Central and Eastern Europe, Far-East Asia, Japan.

Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation