Tchater maintenant avec le support
Tchattez avec un ingénieur du support

NetVault Bare Metal Recovery 13.1.2 - User Guide for NetVault Server

Adding a VTL created on an NFS

1
After NetVault Bare Metal Recovery for NetVault Server has started, change to the /usr/netvault/config directory.
2
Open the diskdevices.cfg file, and locate the [libraries] stanza.
3
After the [libraries] stanza, enter the following line:
location=/nfs-mount-dir/library-name
4
Locate the [drives] stanza, and insert the following line:
location=/nfs-mount-dir/library-name/drives/1
5
If there are multiple drives, enter more lines after the [drives] stanza.
location=/nfs-mount-dir/library-name/drives/2
location=/nfs-mount-dir/library-name/drives/3
…
6
Save and close the file.
7
In the Navigation pane of the NetVault WebUI, click Manage Devices, and then click Add Device.
8
Select the Virtual tape library/media changer and Re-add previously generated virtual device options, and click Next.
9
After the VTL that you previously added is displayed, add the drives as appropriate.

Selecting the BMR target media

The next step is to select a dedicated BMR target media for your backup. To create a Target Set, perform the following steps.

1
In the Navigation pane of the NetVault WebUI, click Create Backup Job.
2
Next to Target Storage, click .
3
Click Device Selection, and select the applicable device.
4
Click Media Options, select the applicable options; enter a user-defined label, for example, BMRMedia string in the Media Label field.
5
Click Media Sharing, and select the applicable options.
6
Click Save to save the set, enter a name in the Create New Set dialog box, and click Save.
The name can contain alphanumeric and non-alphanumeric characters, but it cannot include non-English characters. On Linux, the name can have a maximum of 200 characters. On Windows, there is no length restriction. However, a maximum of 40 characters is recommended on all platforms.

Backing up the source NetVault Server

To back up the server, complete steps outlined in the following topics.

•
Prerequisites for an offline backup
•
Completing the backup

Prerequisites for an offline backup

Before initiating a backup with the Plug-in Server, review the following topics for details on prerequisites that must be met.

 
* 
CAUTION: Even if there is no difference between the system devices in a backup and a restore, the order of the disks might be different. If the restored data is started without performing a rename, any data that exists on the disks is lost. To compare the information of the physical disk at backup and restore, note the Disk Geometry and Device Size at backup.
Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation