Tchater maintenant avec le support
Tchattez avec un ingénieur du support

Change Auditor for EMC 7.2 - User Guide

Introduction

 

Verify auditing template is applied

To ensure EMC events are being captured, check to see if the agent assigned to the EMC Auditing template is using the latest agent configuration.

1
Select Start | All Programs | Quest | Change Auditor | Change Auditor Client.
2
Select View | Administration.
4
Select Agent in the Configuration task list to open the Agent Configuration page.
5
Select the agent assigned to the EMC Auditing template (Auditing appears in the EMC column) and click Refresh Configuration.

Make changes and run a report

2
Select Start | All Programs | Quest | Change Auditor | Change Auditor Client to review the events generated.
4
Expand the Shared | Built-in | All Events folder in the left-hand pane.
5
Locate and double-click All EMC Events in the right-hand pane.

Troubleshooting steps

If the EMC events do not appear in the client as expected, check the following:

server_cepp <DataMoverName> -p -i
server_cepp <DataMoverName> -service -stop
server_cepp <DataMoverName> -service -start
Verify that the EMC file server (CIFS) is valid on the first page of the EMC Auditing wizard. The EMC File Server (CIFS) field should contain the IP address or Netbios name of the CIFS to be audited.
Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation