Tchater maintenant avec le support
Tchattez avec un ingénieur du support

NetVault Plug-in for Oracle 13.0 - User Guide

Introducing Quest® NetVault® Plug-in  for Oracle Defining a backup strategy Installing and removing the plug-in Configuring the plug-in Backing up data Using the Oracle Flashback Database Restoring data
Restoring and recovering data: an overview Performing User Managed restores Using advanced User Managed restore procedures Performing RMAN restores Using RMAN types of recovery in a non-RAC environment Using advanced procedures with RMAN restores
Maintaining the Recovery Catalog Using the RMAN CLI Using the plug-in with Oracle RAC Using the plug-in in a failover cluster environment Using the plug-in with Oracle Data Guard Using the plug-in with Oracle Container Databases (CDBs) and Pluggable Databases (PDBs) Troubleshooting

Configuring default attributes

NetVault (required for RMAN backups in a RAC environment): Specify the name of the NetVault Server where the Oracle Database Server was added as a NetVault Client.
Do Restores from NetVault Server (required for RMAN backups in a RAC environment): Specify the name of the NetVault Server where the Oracle Database Server was added as a NetVault Client.
CLI Backup/Autobackup Target Set (required for RMAN backups in a RAC environment): Specify the name of the Backup Target Set that was specified in the Configuring a default Target Set for RMAN backups.

Determining the local Oracle SID and Home directory in a RAC environment

In a multi-instance RAC environment, the local SID and Oracle Home can be determined with the srvctl config database commands.

3
Run the following command, where <database_name> represents the database that is being added to the plug-in:
<node> <local Oracle SID> <local Oracle Home>

In the following example, Plug‑in for Oracle is being installed on the “faro” node, the local Oracle SID is “o10rac3,” and the local Oracle Home is “/home/o10g/db.”

Adding a database to the plug-in

Adding a multi-instance database in Plug‑in for Oracle is almost identical to adding a single-instance, non-RAC database except for the following differences:

Oracle SID: Enter the local SID for the target RAC database. The local SID is the instance name for the target RAC database on the node where the plug-in is installed.
Parameter File(s) Path: In a multi-instance RAC environment, the plug-in requires the usage of an SPFILE as a dynamic method of maintaining initialization parameters. The SPFILE must be stored on the shared storage in ASM. Because the SPFILE is included in the Control File Autobackups, this field should be left blank in a RAC environment.
Control File Autobackup enabled: Select this option because Control File Autobackups are required in a RAC environment.

For more information, see Configuring the plug-in.

Backing up data

RMAN-based backups are the only supported backup method for multi-instance RAC databases. RMAN is RAC-aware in that it automatically identifies that a database is a multi-instance RAC database and backs up the selected data accordingly.

With the plug-in installed on one of the nodes that hosts one of the instances for the RAC-enabled database, all RMAN-based backups and restores are performed from this single installation of the plug-in.

The Parameter File node is not selectable on the NetVault Selection page.

For more information on selecting data for backup, setting backup options, and finalizing and submitting the job, see Performing RMAN backups.

Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation