Tchater maintenant avec le support

Obtenir une aide instantanée
Terminer l’enregistrement

Se connecter

Demander les tarifs

Contacter le service des ventes

NetVault Plug-in for NDMP 12.2 - Application Notes for Dell FluidFS

Parcourir le contenu

About Dell FluidFS

Key benefits

About this document Target audience Recommended additional reading

Installation and configuration prerequisites

Use cases Installation prerequisites Configuration prerequisites

Authentication Local device topology

Adding the Dell FluidFS NAS Add devices in NetVault Backup Assumptions

Backing up data

About Backup Dump levels Backing up data using the plug-in Backup content filtering Backing up replica NAS containers Backing up individual data paths

Restoring data using the plug-in Restoring Incremental Backups Renaming or relocating data Restoring data to an alternate filer Restoring data from or to a Replica NAS Container Searching for files in savesets Viewing media list

Troubleshooting

Common errors

Adding the Dell FluidFS NAS

You can configure the Dell FluidFS to use one or more NAS Cluster IP addresses. When you add the Dell NAS Server to the Plug‑in for NDMP, use any one of the NAS Cluster IP addresses.

Add devices in NetVault Backup

On the NetVault Backup Server machine, add the library attached to the filer to the NetVault Backup Server to configure using the local topology. Ensure that the devices added are relative to the FluidFS.

To add a device, see the Quest NetVault Backup Administrator’s Guide.

Assumptions

It is assumed that the users implementing the procedures described in this document have expertise in the following areas:

•

NetVault Backup installation, configuration, and administration.

•

FluidFS Server configuration and administration.

•

Intermediate networking expertise, including routing, name resolution, and TCP/IP.

•

Intermediate NFS and CIFS Protocol setup and administration expertise.

•

Intermediate Windows Authentication and Active Directory administration expertise.

Backing up data

•

About Backup Dump levels

•

Backing up data using the plug-in

•

Backup content filtering

•

Backing up replica NAS containers

•

Backing up individual data paths

Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation

© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Conditions d’utilisation Confidentialité Cookie Preference Center