Tchater maintenant avec le support
Tchattez avec un ingénieur du support

Foglight 5.9.4 - Installing Foglight on Windows with an Embedded PostgreSQL Database

Before Installing Foglight Installing Foglight
Preparing to install Installing a new version of the Management Server Installed directories Foglight settings Uninstalling Foglight Upgrading the Management Server
Running the Management Server Installing and Upgrading Cartridges Installing Agents Appendix: Switching from an Embedded to an External Database

Step 12: Foglight ports configuration

Step 12: Foglight ports configuration
1
Configure the server ports. The Foglight Ports Configuration screen displays default ports that you can assign.
 
* 
NOTE: In certain configurations, the Management Server uses other ports than the ones that you can set on this screen. See the Administration and Configuration Help for details.
2
If you want to revert to the default values, click Defaults.
3
Click Next.
 
* 
NOTE: If there are any port assignment conflicts, an error message dialog box appears. Click Review Ports, if you want to return to the Foglight Ports Configuration screen to configure the conflicting port(s), or click Ignore and Continue to continue with the installation without resolving the port conflicts. Select one of these options to continue.

Step 13: Add Foglight license file

Step 13: Add Foglight license file
1
Specify the path to the Foglight license file in the Install a license from the following file box, or browse to a license file by clicking the Browse button.
 
* 
IMPORTANT: See the Administration and Configuration Guide for information about license requirements, managing licenses, and the different categories of cartridges (based on their license requirements).
2
Click Next.
Alternatively, you can provide a license file to the Management Server after the installation is complete. To do so, leave the Install a license from the following file box blank and click Next.

If you selected Enable Foglight as a Service in Step 6: Foglight Service, the Management Server service is enabled and started at this point.

 
* 
NOTE: You can install Foglight for Virtualization, Enterprise Edition with the default option of a 45-day trial license, or import an existing license. To install the default option, select Install a trial license, then click Next. To import an existing license, follow the preceding procedure.

Step 14: Add Foglight to system service

Step 14: Add Foglight to system service

The Foglight Server Startup step enables to add Foglight to the system service.

* 
NOTE: To customize the Foglight Management Server starts as a system service, the current user must have sudo without password privilege; otherwise the script will be generated without being added into the system service and you can edit and execute the script later.
1
To start the Foglight Management Server without adding Foglight to the system service (the default setting), click Next.
2
To start the Foglight Management Server as a system service, select Yes, add foglight to the system service.

Step 15: Foglight server startup

Step 15: Foglight server startup

The Foglight Server Startup step enables you to start the Management Server.

 
* 
NOTE: This screen does not appear if you enabled Foglight to run as a Windows® service.
1
To start the Management Server (the default setting), click Next.
If you do not want the installer to start the Management Server, clear the Run Now check box, then click Next.
2
If you selected Run Now, the installer starts Foglight and the Foglight Server Startup page launches in a web browser (if a web browser is available). If a web browser is not available, the Foglight Server Startup page does not launch.
See Foglight Server Startup page for more information.
In either case, the Install Complete screen appears.
Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation