立即与支持人员聊天
与支持团队交流

NetVault Bare Metal Recovery 12.4 - User Guide for NetVault Backup Server

Setting restore options

On the Create Selection Set page, click , and configure the following parameters on the Options tab:

Ensure that Physical Machine is the selected Restore Type.
In the Restore Name box of the Physical Recovery Options section, verify that the correct name is displayed.
By default, the value in this field is the name of the NetVault Backup Server from which this backup was originally performed, based on the backup saveset selected from the Create Selection Set page. This name is associated with a specific IP address that was previously configured. If this value is left at its default setting, selected data is restored to a machine that uses the same information as the machine that was originally backed up.

Finalizing and submitting the restore job

The final steps include setting additional options on the Schedule, Source Options, and Advanced Options pages, submitting the job, and monitoring the progress through the Job Status and View Logs pages. These pages and options are common to all NetVault Backup Plug-ins. For more information, see the Quest NetVault Backup Administrator’s Guide.

1
To save the settings, click Ok, and then click Next.
2
In Job Name, specify a name for the job if you do not want to use the default setting.
3
In the Target Client list, select the machine on which you want to restore the data.
TIP: You can also click Choose, and then locate and select the applicable client in the Choose the Target Client dialog box.
4
Use the Schedule, Source Options, and Advanced Options lists to configure any additional required options.
5
Click Save or Save & Submit, whichever is applicable.
You can monitor progress on the Job Status page and view the logs on the View Logs page. For more information, see the Quest NetVault Backup Administrator’s Guide.
相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级